Forum > General Tech
Floor Pans
75JOE:
Should I use pans from one of the vendors or try to fab from sheet metal. Kelly Sheet Metal quoted $54.00 for a 8x10 sheet of 18 ga. and will cut it down to rough sizes I would need? Floor will be covered with vinyl or carpet so appearance will not be an issue. I realize that without the ribs there may be some flex.
I have never done fabrication, and do not currently have a metal brake.
Also, didn't some of you use Raptor Liner? If yes, how has it held up and are you happy with it?
JustaFordGuy:
I made my own but the vendor replacements will be easier. I only made my own so I could justify buying a plasma cutter, metal brake and new welder. ;D
I think Bret used the Raptor liner and it turned out nice but he isn't finished with his Bronco so not sure how it will hold up long term.
75JOE:
Thanks. Will probably go with the vendor pans. Will get a new MIG for the process.
Any other suggestions for DIY liner?
lonesouth:
I used POR15 and then covered with peel and seal. I've got some POR left over and it is yours if you want it. I keep it in the fridge, per the directions, so it should be good.
JustaFordGuy:
Hey Joe, How's the floor pan project going?
Navigation
[0] Message Index
[#] Next page
Go to full version