What have you done to/with your Bronco today?

[BroncoBlair]

I Wired up a switch on electric fan (used an old headlight switch bezel to make the switch match the others on dash).
Installed fender Flares on drivers side and started passenger side.
Installed a radio Antenae.
Installed new wiper switch.
Tonight I will start on installing new drive shaft, new ubolts, and finish the passenger side flares. Then its time to replace front axle seals and ball joints

[JustaFordGuy]

Sounds like you made good progress. If you want to do the ball joints soon you should spray them down with some blaster so it can soak in.

[williamknapp79]

wow that raptor stuff looks like it could be used for just about anything

[JustaFordGuy]

I fixed my window crank. I also used the Bronco to pull the mustang out from under the car port. It had a burn fuseable link so it wouldn't start.

[williamknapp79]

stripped out all my interior and hood doors and tailgate getting ready for minor floor pan replacement and repair on door skins and hood and then its time to decide how i wanna redo the seats to match up with the candy red and mother of pearl paint and start with lil user friendly mods to the interior 

[BroncoBlair]

Replaced alternator with new Chrome GM one wire alernator. Had to drill out hole to allow for larger bolt. had to relocate ground to keep in from contacting post on alt. Washed tons of mud out of everything. installed two more speakers, rewrapped header on passenger side. took side windows and rear window out to allow rain to more easily enter the vehicle (just kidding just bad timing on that one).

[JustaFordGuy]

I guess you got it home OK?

[lonesouth]

finally installed the gear gawker i've had sitting on my workbench for the last year.

[JustaFordGuy]

That's ki

finally installed the gear gawker i've had sitting on my workbench for the last year.

That's cool. How thick is it? I have some 1/4 lexan, I wonder if it would hold up?

[lonesouth]

1/4 on the lip, 1/2 in the middle.  it is reinforced(a la bulletproof) glass.  lexan would probably work for what we do.

[FloridaBronco]

that's pretty cool there Parker. im not sure I want to see in my junk....

[lonesouth]

I finally got around to washing mine and installing a fire extinguisher on the roll cage.


looks imposing, but it doesn't obstruct the view at all.

[BroncoBlair]

The move is over time to get back to the Bronco.

First a disc brake swap , then Paint

Hopefully by the end of summer it will be Blue 

[Jcrum]

Late post but last week I painted the the wind shield frame, both front door post and the dash. I have working on adding a 12 foot lean to to my garage for my boat, before I replace the rotten floor in the boat. I post pics later   

[FloridaBronco]

alignment!